The compressor must be installed in a well-ventilated, dust-free room.
The maximum permissible ambient air temperature is 40°C.
Ensure sufficient ventilation and proper conditions for the incoming air.
Ventilation openings and compressor outlets must remain unobstructed and at least 150 mm away from objects. Direct exposure of condensate on the compressor is not permitted.

Secure the mounting plate to the wall at the intended location of the compressor. The location should preferably be near the water supply for easy access and maintenance.
The compressor is fastened to the mounting plate using 4 screws. Select two of the holes on the plate that are 65 mm apart.
The delivery set includes an 8 mm diameter, 2 m long PET discharge pipe. One end is connected to the compressor outlet (1/4″) using a threaded fitting (coupling). The other end is connected to the inlet of a ½” threaded fitting on the water supply line. To facilitate installation, a small amount of silicone can be applied to the pipe ends. An S-bend must be installed to prevent water hammer. The PET pipe is secured using OMT-generali clamps.
A check valve must be installed on any section of the PET pipe to prevent water from flowing back into the compressor. The arrow on the check valve indicates the direction of flow from the compressor to the water supply.
For safety, it is recommended to install two valves (included in the delivery set) on the water line: one before the direct connection to the compressor and one after, to shut off the water during maintenance.
The PET pipe with fitting is installed using a quick-connect IVZ-type fitting. No additional sealant or gaskets are required. The pipe section is first bent at a 90° angle, then pushed into the fitting until it clicks into place. This connection provides a sufficient seal to prevent unwanted leaks.

Note:
To remove the pipe from the quick-connect fitting, press the O-ring collar towards the fitting and pull out the pipe section.